# DD-WRT v24 RC4 (2007-10-10) # is280 demo Download the v24 bin file. Push the Reset Button for 10 seconds # cat5 the laptop to is280 wireless router # verify that laptop has pulled a 192.168.1.x IP address browse to: http://192.168.1.1 Administration (click on this tab) Enter username "root" and "admin" Administration > Factory Defaults > > Reset to factory settings * > Apply Settings Administration > Firmware Upgrade > > Flash with v24 rc4 * > Apply Settings Administration > Factory Defaults > > Reset to factory settings * > Apply Settings = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = # cat5 the laptop to is280 wireless router Setup > Basic Setup * > Local IP Address [192].[168].[140].[1] * > Apply Settings # you will need to get a new IP address # plan A: ipconfig /release, ipconfig /renew # plan B: unplug your cat5 cable for 10 seconds verify that you did get a 192.168.140.x IP address # you will need to log in again Security > Firewall # to allow ping testing to work * > SPI Firewall > Disable * > Apply Settings = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = # cat5 the laptop to is280 wireless router Wireless > Basic Settings Wireless Physical Interface wl0 Physical Interface wl0 - SSID [byuh] HWAddr [...] * > Wireless Mode: [Client] * > Wireless Network Name (SSID): [byuh] * > Apply Settings # verify that is280 has pulled an IP address # verify that you can see web pages = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = # cat5 the laptop to is280 wireless router Wireless > Basic Settings Wireless Physical Interface wl0 Physical Interface wl0 - SSID [byuh] HWAddr [...] * > Wireless Mode: [Repeater] = > Wireless Network Mode [Mixed] * > Wireless Network Name (SSID): [byuh] * > Wireless Channel [Auto] (does not seem to matter) = > Wireless SSID Broadcast (o)Enable = > Network Configuration (o)Bridged * > Virtual Interfaces [Add] Virtual Interfaces Virtual Interfaces wl0.1 SSID [is280] * > Wireless Network Name (SSID): [is280] = > Wireless SSID Broadcast (o)Enable = > AP Isolation [Disabled] = > Network Configuration (o)Bridged (from is280 to byuh) * > Apply Settings = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = = Administration > Management > > Router Password: whatever > > Re-enter to confirm: whatever > > Apply Settings # re-enter username "root" and password Services > Services > > SSHd: (o)Enable > > Telnet: (o)Disable > > Apply Settings Wireless > Basic Settings = = Wireless Mode: [AP] = = Wireless Network Mode: [Mixed] > > Wireless Network Name (SSID): [is280] > > Virtual Interfaces [Add]